|
|
|
|
The HD-8 Shaver post driver shown above has the manual angle tilt of 15 degrees either direction to make sure you drive your posts straight, and delivers 30,000 lbs at full stroke force and can drive 4-5 inch posts in less than 15 seconds. All models take just a few minutes to mount or detach. All work with any 3-point hitch, with or without Quick-Tach. Shaver post drivers can be mounted on tractors or skid steer loaders.
Shaver Hydraulic Post Driver
|
|
|
|
|
|
|
|
|
|
|
|
|
More
Features and
Specifictions |
HD-8 |
HD-10 |
HD-12H |
Impact at Full Stroke |
30,000 lbs. |
71,500 lbs. |
100,000 lbs. |
Effective Weight of
Spring Powered Hammer |
360 lbs. |
725 lbs. |
1,100 lbs. |
Drives a 4-5" post in as little as 10 seconsds. |
Operating Distance
Above Ground |
53-126" |
53-128" |
53-128" |
Operating distance above ground is adjustable on all models. |
Post Size:
Maximum Width
Maximum Length |
Drives steel, wood posts, railroad ties |
7 1/8"
10 feet |
8 3/4"
10 feet |
10 7/8"
10 feet |
No. of Block Studs |
4 |
4 |
6 |
No. of Nyrim Blocks |
4 |
4 |
6 |
Tilt:
With Hydraulic Base
With Manual Base Plate |
Front-back/side-side
15°/15°
15°/15° |
Front-back/side-side
15°/15°
15°/15° |
Front-back/side-side
20°/25°
N/A
|
Hydraulic Base Plate and
Manal Stabilizer Pad
pkg. |
optional |
optional |
optional |
Category I, II, or III
Assembly |
category I |
category I |
category II |
Adjustable with all models 25.0" - 40.5" |
Mounting |
front or rear or skid ldr. |
front or rear or skid ldr. |
rear or skid ldr. |
Whicever you shoose, it takes just a few minutes to mount or detach. Works
with any 3-point hitch, with or without Quick-Tach |
Hydraulic Requirements |
3-4 GPM/1,500 PSI |
12 GPM/1,500 PSI |
15 GPM/2,000 PSI |
Shipping Weight:
With Hydraulic Base
With Manual Base Plate |
(Weights listed are approximate) |
486 lbs.
438 lbs. |
714 lbs.
694 lbs. |
957 lbs.
N/A |
|
|
|
|
|
|
|